Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Majkel

Pages: [1]
1
Sherco Tech / [2020] 300 se factory, cracks in frame
« on: June 12, 2021, 02:45:37 AM »
Hello,
Just found some cracks in the frame of my 300 se factory 2020.
Anyone else who has experienced this or heard of it.

Is it possible to weld this or what do do?

2
Sherco Tech / [2020] 300 se factory, no power/stuttering on high rpms
« on: June 10, 2021, 07:45:32 AM »
Hello,
Recently my 300 we factory started to loose top end power, it never revs out and instead starts stuttering. It will continue to run (not bogging dead) if I keep holding full throttle but never revs out/kicks. Low/middle works like a charm and no starting or idle issues.
I didn't have any problems before, but noticed last ride that it started to go a little unclean on higher rpms. But it revved after 2-3 seconds with full throttle. Now as meantioned, it cannot rev out at all.

Current jetting: main 172, pilot 40, n8re second clip, 1 1/2t,  running 40m above sea level.

I have checked following:
- Power valve is not stuck.
- No bad cables etc.
- Cleaned carb.
- Tried leaner jetting
- Checked reeds.
- No air leak

I haven't done any electrical measurements.

I start to suspect that the power valve servo is malfunctioned or it might be bad coiling... but maybe someone here have an idea what the problem could be?

Pages: [1]