Author Topic: 2022 Sherco 300 SE Factory - Hard Clutch Pull  (Read 1349 times)

TTBadDog

  • Junior
  • **
  • Posts: 58
    • View Profile
Re: 2022 Sherco 300 SE Factory - Hard Clutch Pull
« Reply #15 on: December 22, 2021, 03:38:27 AM »
I went with 3 KTM springs then added the Midwest lever. The Midwest lever uses the full travel of the lever so there is a lot of engagement zone. Once the MW lever was on I removed one of the KTM springs so I know have 2 KTM springs.

Any idea if the 3 spings is a contributor to slipping?  I figured it might be so I should be OK with 2 KTM springs. If you think about it the only time the springs can contribute to wear is when the clutch plates are going back to fully loaded by the springs or loaded by the springs. When the clutch is partially or fully engaged the basket is held in check by the hydraulics. If I am thinking correctly the 2 KTM springs should be OK and not cause any added slipage.
2022 250 SE Factory